Image Enlargement (bokeh/NSFW)

图像放大(bokeh/NSFW)

Note:

The sample diagram is independent of the workflow

注意：

示例图与工作流无关

• bokeh supports larger image magnification and adopts a block method. The best resolution provided by the official is greater than or equal to 1024, and the model based on the SD3.5 series itself supports NSFW

  Advantages:

  Supports NSFW and has wider applicability

  Large-sized resolution image output

  Disadvantage:

  The phenomenon of limb collapse still exists. If the original image is an AI image or the original image is not clear, the probability of limb collapse drawn is high. (In this workflow, Controlnet line drawing control can be added. Of course, it can also be replaced with depth control and adjusted according to the situation to increase the success rate of limb drawing. When Controlnet is enabled, It can increase the noise reduction value by about 0.5. When not turned on, it is recommended to increase it by about 0.3.

• 支持更大的图像放大，采取分块方式,bokeh在官方提供的最佳分辨率上均大于或等于1024，并且基于的SD3.5系列的模型本身就支持NSFW

  优势：

  支持NSFW，适用性更广

  大尺寸分辨率出图

  劣势：

  肢体崩坏的现象依旧存在，如果原图是AI图或者原图不清晰，画出的肢体崩坏概率大（在本工作流中加入Controlnet线稿控制，当然也可以替换成深度控制，根据情况来调整，从而提高肢体绘制成功率，在开启Controlnet的时候，可以提高降噪值0.5左右，未开启的情况下，建议0.3左右）

• Parameters to be adjusted:

  1.After partitioning, the proportion of overlapping images should be determined to ensure that the resolution of each image is greater than 1024

  2.Controlnet can be turned on or off, but pay attention to the noise reduction value at the end

  3.The noise reduction value is approximately 0.3 to 0.5

  4. The number of blocks can be modified as needed

• 需要调整的参数：

  1.分块后重叠图像的比例，确保每块图像分辨率大于1024

  2.Controlnet可以开启也可以关闭，但注意后面的降噪值

  3.降噪值0.3-0.5左右

  4.分块数可以视情况修改